Aeotec Nano switch fitting

The Aeotec nano switch looks simple enough to fit, I just need to establish which wires go where.
I found a picture on the internet that shows this better, but I have 2 red wires going into C and 1 wire going into 1.

Now I am not an electrician, but I need to check that the 2 wires in C,  I class as Live for the purposes of connecting to the Aeotec switch and the single wire in 1 is the load.
If that is correct, I can get this wired up

The picture below shows a single nano switch

• The current wire labelled C which goes into the light switch , needs to be plugged into the port labelled L on the nano switch
• The neutral that is currently on the left picture and unused needs to be connected into the port N on the nano switch
• The L and IN need to be bridged on the nano switch
• The wire that goes into 1 on the light switch needs to plug into OUT on the nano switch
•